DSA J1939 Converter Box for OmniTRACS® and OmniExpress®
Allows use of OmniTRACS® and OmniExpress® hardware on a vehicle with a J1939 data bus.
Navigation
Downloads
Qualcomm J1939 Converter Box Firmware
This is the current version of the Qualcomm J1939 Converter Box Firmware.
Download and Save this file to your PC and then run (i.e. double-click) it to extract the binary (.bin) file needed by the Reprogramming Utility. The .bin file will be extracted to the same folder where the file was saved.
Refer to the Reprogramming Instructions in the Documentation Section for more information on how to install new firmware in the Converter Box.
Click Here To Download (version 2.2.6 - released 7/27/2009)
Gateway Reprogramming and Diagnostic Utility
The DSA Gateway Reprogramming and Diagnostic Utility software is available as a free download. This software is used to upgrade of the firmware in the J1939 Converter Box, and the built-in diagnostic functions are helpful for troubleshooting problems with the Module or OmniTRACS® system.
This software can be used with the DSA D-Net Module or any RP-1210 compliant communications device.
Click Here To Download (version 1.0.0.6 - released 2/16/2009)
DSA DNet RP1210 Driver
The DSA DNet is a low-cost RP1210 compliant communications adapter suitable for use with the DSA Gateway Reprogramming and Diagnostic Utility and any other software requiring J1587 or J1939 communications through a RP1210 interface.
This driver must be installed before the D-Net Module can be used. Download the latest driver installer below:
Click Here To Download (version 2.0.2.1 - released 1/07/2011)